"Moose Bite" SBCAR for Pro Nerf Blasters
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
SBCAR suitable for 150 - 350 FPS blasters.
- Ocena
- 5 / 5
- Polubienia
- 80
- Pobrania
- 411
- Wydruki
- 11
- Wyświetlenia
- 1753
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Bearing orientation is marked on the prints themselves and it's not what you expect.
Long collet needs 43 mm of barrel to attach to and is recommended for a tight concentric fit.
Shorter collet needs 25 mm of barrel.
Hardware is either 9 or 15 F683ZZ bearings and either m3x14 (or longer) pins, or m3x10 (or longer) screws.
I sell the bearings and pins for a buck a piece here https://moosemodshop.com/products/3-3x7x3-bcar-bearings-and-pins
Amazon link for bearings: https://www.amazon.com/dp/B0F4XRNC96?ref=cm_sw_r_cso_cp_apin_dp_N7QCF6YZ33DQNKJCJ848
This was created from smashing my zinc PCAR into Chance's BCAR that I've assembled backwards and leaning the bearings in to engage with the darts across the whole bearing surface.
The cutting files are there for designing your own or using the geometry to integrate it with another blaster altogether.
If you want to sell these feel free to reach out to me the Moose Mod Shop Discord and we'll work out an arrangement.
https://discord.gg/EBNumh8C2u
Thanks to Kuzco for the assembly tool!