Wanhao I3 Duplicator Filament Sensor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple 3d printable Filament Sensor for the Wanhao i3 Duplicator V2 using a simple limit switch.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 270
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Wanhao I3 Duplicator Filament Sensor
I Really liked the TUSH - The Ultimate Spool Holder remix for the Wanhao i3 Duplicator, so I decided to add it to my printer. After this, I decided I needed some form of FIlament Sensor to never come back to a half printed print... we've all been there. This design utilises a limit switch and Octoprint to pause the printer whenever the filament runs out. The particular limit switch is linked below. The design is purposely made to rotate with the twists in filament as this makes sure that the filament is not under too much tension to cause a failed print. On top of this, I started developing a group of upgrades to the Wanhao i3 Duplicator, which are linked below; these upgrades include lighting, BLTouch mount and finally, a raspberry pi case.
Equipment List
- 2 x M2 Nut
- 2 x M2x12mm bolt
- 1 x M3 Nut
- 1 x M3x8mm bolt
Useful Links
- Octoprint
- Limit Switch
- Filament runout plugin
- Wanhao i3 Filament Spool Holder
- Raspberry Pi Wanhao i3 Case Thing
- Wanhao Camera Mount
- BLTouch Mount
- Wanhao i3 Poundland Light Fitting Thing
Print Settings
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 V2
Rafts:
No
Supports:
No
Resolution:
0.4mm
Infill:
5%
Filament:
PrimaValue PrimaValue PLA
Notes:
For best results, use a brim and supports for the bolt holes to allow for a flush bolt at the assembly stage.
Technical Drawing
