Wind Tunnel For Testing Airfoils
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A wind tunnel I made to test different airfoils.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 163
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Engineering
- Licencja
- Creative Commons — Attribution
This is the wind tunnel I made to test different airfoils.
Materials:
A 3d printer
Filament
40x40cm of 30 mesh ( squish between the hollow 40x40cm square spacer and contraction cone)
4 120mm fans
A fan speed controller
sheet of acrylic for viewing section
fog machine
hot glue gun for connecting everything together
I did not pre slice anything because my printer is pretty large and many things I printed on my printer would probably not fit on the majority of printers.
For the smoke, I used a fog machine and a long metal pipe directed at the middle of the honeycomb. I recommend getting a fog machine that has variable fog settings since mine did not and there was only a slim few second window where the smoke was just the right amount to get a clear shot.