Snapmaker U1 Super Simple Cover Adapter for Ikea Samla
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A quick print option for those who don't need full enclosure or heat retention. I.e. PLA or similar filaments.
- Ocena
- 3 / 5
- Polubienia
- 8
- Pobrania
- 36
- Wydruki
- 1
- Wyświetlenia
- 356
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
UPDATED 2026-06-15:
- Added 3 sizes. 25mm is the smallest that works with the Ikea Samla, without wires bumping it.
- Adjusted left-to-right fit. Now centered perfectly with the Samla tub.
- Adjusted fit of the insert part. No longer purely relies on gravity.
- Adjusted refinements (chamfer/fillets)
- Adjusted printability. Now prints cleanly (hollow) with only a small flat support section.
The Ikea Samla most recommended as a Snapmaker U1 cover is not tall enough on it's own to work without interfering with the printer's Bowden tubes. Some additional height is needed.
I just needed thermal and draft stability for PLA, so didn't need the fully sealed enclosure plans others have made. To avoid hours of printing and much more filament use, I designed these simple props instead. They fit in the Snapmaker U1 hood mounting points, and you just place the Ikea Samla tub over them.
Gravity and a bit of a U-shape has been plenty to hold this together through months of printing.
SUPPORTING YOUR FAVORITE DESIGNERS:
If you want to help inspire me to post more stuff, please consider using the affiliate link below to get to Amazon the next time you are inclined to go there.
PLA+: https://amzn.to/4wZ4J8J
INSTRUCTIONS:
Print 2
They are sort of directional. Place both opposite each other so they are in the mounting point at the back (or front I suppose).
Put the tub on. Be careful of the Bowden tubes. The Samla can catch on them.