1 / 4
Yamaha drums - tube clamp 38x38mm
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount additional pads on your drum kit :)
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 76
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial
When I got a few mesh pads and replaced the rubber pads on my Yamaha drum kit, it felt like a waste not to use the latter to expand the kit a bit. Mounts for the tube were needed. This is exactly that kind of holder :)
To ensure strength, print at a 45-degree angle (as shown in the photo) with a gyroid infill of at least 50%. Also, add supports in the gaps. My knob with an M6x40 nut and bolt fits this holder: