Rounded LED Strip Channel

I created this LED Strip channel as mentioned in the short blurb from another one someone had made, however I hand crafted this in FreeCAD myself and made all of the adjustments to ensure the pieces fit together properly (somewhat tight just as a heads up).

The rails can be printed normally like any other prints, in my case I did them all in Overture White PETG.

For the diffusers you will need to print that in vase mode most likely, I had issues when printing normally where one side would over-extrude on me making it incredibly if near impossible to fit into the rail.

As far as the parts list I used to make it all work in the end for me personally:

• Input power cable, just cut off the female end as it was unneeded:

  • https://a.co/d/0eztbjnN

• The AC to DC power supply that fits in the attached model for the box (though it may be overkill):

  • https://a.co/d/005EOt9Q

• LED Strip (cut sections out to bring down to required size):

  • https://a.co/d/08awcjcA

• LED strip connectors:

  • https://a.co/d/054coL4y

•  Power and Data cable for running between sections:

  • https://a.co/d/0hlS8Uwi

• LED Controller - ended up using a esp32 with one add-on for an external antenna to ensure connectivity because I ran into issues originally:

  • Xiao Esp32-C6: https://www.seeedstudio.com/Seeed-Studio-XIAO-ESP32C6-p-5884.html

  • External antenna: https://a.co/d/0fZfAjJg

• Other supplies:

  • Aluminum strips 1/8" thick by 3/4" wide from the hardware store used as a heatsink

  • Command strips for mounting (these were used under the bars and to attach it to the cabinet)

    • https://a.co/d/0bFVqB5c

If you have any suggestions or improvements feel free to let me know or make them yourself and upload a remix.