SNES USB-C Power Mod Adafruit Board Backplate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A backplate for regular SNES consoles intended to allow for the mounting of an Adafruit USB-C trigger board.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 123
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution
PLEASE NOTE: The Super Nintendo is a sensitive piece of vintage electronics. Powering the system with any form of inferior power supply can and will cause issues and shorten the life of the console. USB-PD is not inherently dangerous, but cheap or untested USB Power Supplies are. Many experts recommend avoiding USB-C mods because even when done safely, it can be difficult to source or identify safe and thoroughly vetted power supplies. While the "Reflex Volt" line of PSUs are thought of highly, I cannot personally vouch for them electrically.
Never perform any modification that requires removing parts of the systems original power circuitry, or running the system at a voltage other than the original (in this case, 9v). This goes for all vintage consoles, not just the SNES.
Designed using my remix of a similar USB-C backplate for the SNES "Jr" consoles and a standard SNES backplate made by SnarfxxxSnarf on cults3d.
It's intended to allow you to modify your console to run off of USB-C. By installing a USB-C trigger board configured to output 9 volts at 1 amp, you can power the system with any USB-PD compatible power supply without changing any of the original operations of the console. This is superior to other USB-C mods that run off of 5 volts as it allows for more stable power delivery and is more in-line with the systems intended operations.
Requires removing the RF out module from the SNES: there's simply no room to mount this particular board anywhere else.
Should work with all North American non "Jr" Super Nintendos.
Printed in PLA on an Elegoo Centauri Carbon.
All testing was done with this board: https://www.adafruit.com/product/5807
I secured the board with these screws, though they poke slightly out the top: https://www.amazon.com/dp/B0B16PXW25?ref=ppx_yo2ov_dt_b_fed_asin_title