Flambeau 5007 Tuff Tainer Divider
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These fit the new variant marked 2017
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 43
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
I got a good deal on these 5007 Flambeau Tuff Tainers for my kids to sort their extra Lego but they had the Zerust dividers which:
"consist of a proprietary chemical formulation that releases an invisible, odorless, tasteless, and FDA-safe vapor that diffuses throughout an enclosed Tuff Tainer and settles on all exposed metal surfaces to form a protective molecular layer that inhibits the electrochemical reactions that cause rust and corrosion to form"
I didn't like the idea of them inhaling the "safe vapour" so I printed some instead, they can inhale some PLA vapour instead.
It turns out they are much more finicky to fit than it would seem and the ones I found online I couldn't make work so I made my own. The Tuff Tainers also seem to have variances within each one so you can get some that fit tight and some that fit loose with the same divider. You get what you pay for I guess. They will be sensitive to different filaments so I recommend to print 1 and check fitment. You may need to change the brim gap as well if you get any layer shift at the top.
Some tips for printing these:
Print vertical
Use a bed with good adhesion
Don't print too close together
Make sure to check fit and adjust very slightly for different filament that might shrink more
A tight brim is better than a loose brim which will not hold it steady if printing multiples at once (trimming may be required)
Turn 90 degrees if using a bed slinger
Great way to use up the last bits of filament on a roll
Check that yours are the "2017 Flambeau Inc" version the 2016 apparently uses larger dividers (pictured)