Tick Remover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple 3D-printed tick remover with a removal notch and a built-in recess to catch the tick for safe disposal or lab t
- Ocena
- 5 / 5
- Polubienia
- 16
- Pobrania
- 148
- Wydruki
- 1
- Wyświetlenia
- 418
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Medical Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple and effective 3D-printed tick removal tool designed to remove ticks safely and cleanly — without squeezing the body or risking the head breaking off, which are the most common mistakes when using regular tweezers.
Material: PLA or PETG (PETG recommended for outdoor kits — better UV, moisture, and heat resistance)
Layer height: 0.12 or 0.16 mm
Infill: 30%+
Supports: none required
Perimeters: 3+
How to use:
Slide the notch under the tick as close to the skin as possible.
Apply gentle upward tension — do not pull sharply.
Rotate 2–3 turns until the tick detaches cleanly.
Tilt the tool so the tick drops into the recess, then transfer it to a container for lab testing.
After removal: Disinfect the bite site. Do not discard the tick — take it to a laboratory for testing. Early testing allows treatment or prophylaxis to begin immediately without waiting for symptoms. Store the tick in the fridge until tested.
Important: never squeeze the tick's body or use heat — this increases the risk of infection.
