Ceiling Hook for Lamps & Stuff – 30–70 mm [No Glue; No Supports; Only 5 g]
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple no-glue ceiling hook for lightweight lamps, with adjustable hook orientation and 30–70 mm hook sizes.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 44
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Public Domain
This is a simple two-piece ceiling hook designed for hanging lightweight objects such as small pendant lamps, cable-hung lights or decorative items.
The hook consists of a base plate and a separate hook insert. Both parts are simply pushed together — no glue is required. Before screwing the base plate to the ceiling, the hook can be inserted in different orientations, so you can align it to your needs and choose the direction in which the lamp or cable should hang.
The hook is available in multiple lengths from 30 mm to 70 mm, so you can choose a shorter or longer version depending on your setup.
Features
Two-piece design: base plate + hook
No glue required
Adjustable hook orientation before mounting
Hook sizes from 30 mm to 70 mm
Simple screw-mounted base plate
Designed for lightweight lamps and similar hanging objects
Easy to print and assemble
Recommended use
I designed this hook mainly for hanging lightweight lamps from the ceiling. It is useful when you need a clean, simple ceiling-mounted hook and want to choose the hook direction before installation.
Please use appropriate screws and wall plugs/anchors for your ceiling material.
Print recommendations
Recommended material:
PLA+ / PLA Pro with good stiffness and low creep
Use a filament with low long-term deformation under load
Avoid very soft or flexible materials for permanent ceiling loads
Suggested settings:
Layer height: 0.20 mm
Walls/perimeters: 4 or more
Infill: 10%
Top/bottom layers: 5 or more
Supports: not needed if oriented the right way
Print slowly enough to get good layer adhesion
For maximum strength, print the hook with enough walls and good layer bonding. Since this is a load-bearing part, the final strength depends heavily on your filament, print settings, layer adhesion and mounting hardware.
Assembly
Choose the hook size you want to use.
Insert the hook into the base plate in the desired orientation.
Hold the assembled part against the ceiling.
Screw the base plate to the ceiling using a suitable screw and anchor.
Check that the hook is fully seated and the screw is tight.
Carefully test the hook with more load than you plan to use before hanging anything permanently.
Safety note
This part is intended for lightweight objects only. Do not use it for heavy, valuable or safety-critical loads. Do not use it above people, beds, seating areas or fragile objects unless you have tested it properly and are sure that your print, screw and ceiling anchor are strong enough.
Plastic parts can slowly deform over time under constant load, especially with heat. For ceiling lamps, use LED lamps with low heat output and check the hook regularly.