Keychron M6 Rugged Travel Case

This design is a remix of the "Logitech MX Master 3/S Rugged Storage Case" by bbbenji. However this 'Rugged Case' was designed for travelling with the Keychron M6 mouse.

PLEASE READ: I highly suggest you print at least the Outer shells with brims because the Inner Shells are just a exact fit that if the Outer Shells lift off hte build plate even a little, the entire case won't close successfully.

This is labelled "Version 2 (v2)" because the 1st version was just a little too snug of a fit with the mouse cutout. This current design should fit your Keychron M6 Mouse perfectly and keep it nice and protected while travelling. There is a spot for the USB dongle, M6 mouse, and the USB cable. (Honestly this is like version 15 as my son loves to remind me how much filament I wasted test printing so many versions to get the fit just right!)

I have included all the individual .stl files if you want to remix it yourself. I also included a single .3mf file for you to load into your slicer of choice and get to printing.

ATTENTION: There are 3 build plates that are 99% identical. It is Build Plate #2, #4, #5. The reason is because there are 3 version so the Outer Top Shell and the Keychron logo that is inlayed into it. One where it is all black (for those of you without multicolor printers). There is another one with the logo and text in another color (So 2 total colors). Then there is another build plate that has the circle logo in 1 color, logo text into a 2nd color, and the box in a 3rd color. So use whichever you fancy!

I printed mine on a Creality K2 Plus printer which obviously has a larger print bed then most, so plan accordingly.

I am going to list out the details for each of the 5 Build Plates:

Build Plate #1: Both Inner Shells.
- Top Surface Pattern: Hilbert Curve
- Sparse Infill Density: 10%
- Print Time: 4 hours 41 minutes
- Filament Weight: 189.6 grams

Build Plate #2: 3-Color Outer Shells
- Bottom Surface Pattern: Hilbert Curve
- Sparse Infill Density: 10%
- Print Time: 5 hours 25 minutes
- Filament Weight: 174.48 grams

Build Plate #3: 6 Pins & 2 Clips
- Sparse Infill Density: 100%
- Print Time: 35 minutes 8 seconds
- Filament Weight: 7.47 grams

Build Plate #4: 2-Color Outer Shells
- Bottom Surface Pattern: Hilbert Curve
- Sparse Infill Density: 10%
- Print Time: 5 hours 18 minutes
- Filament Weight: 171.27 grams

Build Plate #5: 1-Color Outer Shells
- Bottom Surface Pattern: Hilbert Curve
- Sparse Infill Density: 10%
- Print Time: 5 hours 7 minutes
- Filament Weight: 167.46 grams

Global/Standard Printer/Print Settings:
- Creality K2 Plus Printer
- eSUN PLA filament (Cold White, Black, Orange)
- Creality Textured PEI Plate
- 0.4mm nozzle
- 0.16 Layer Height
- Outer Brim on Outer Shell and Pins
- No Supports

I have tested out Infill down to 8% and it works fine for me, but your mileage may vary.