Ubiquiti Cloud Gateway Fiber mounting corners
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ubiquiti Cloud Gateway Fiber vertical mounting corners
- Ocena
- 4 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 117
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Vertical mounting corners for the Ubiquiti Cloud Gateway Fiber.
I wanted to mount my UCG Fiber vertically on a piece of plywood.
The corner near the power supply needs to be slightly smaller so that's the oddball.
The other 3 corners are the same.
The print model is for all 4 corners, but when I started installing them, I found 3 corners were sufficient so I didn't bother with the fourth.
This leaves all of the vents & ports clear, including the reset hole.
It also keeps a small space between the plywood and the bottom of the unit.
Installation
You'll need 4 screws (3 if you only use 3 corners) with a pan/wafer/flat head.
I used sheet metal screws because they were handy: #8 x 3/4in wafer head.
I'm sure there are other ways to do this, but I held the unit up with the bottom left (the short corner near the power supply) to the board then screwed in the screw. Then I slid the other bottom corner in place, levelled it, and screwed in.
It actually holds with just the bottom 2, but I wasn't comfortable leaving it that way. So slide on the top corners in place snuggly and drive in the screw.
Printing
I didn't use any supports, but I did end up with some delamination for a couple of the passes in the curve. Figured I didn't care that much.