Ubiquiti Cloud Gateway Fiber mounting corners
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Ubiquiti Cloud Gateway Fiber vertical mounting corners
- Rating
- 4 / 5
- Likes
- 1
- Downloads
- 11
- Makes
- 0
- Views
- 117
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Vertical mounting corners for the Ubiquiti Cloud Gateway Fiber.
I wanted to mount my UCG Fiber vertically on a piece of plywood.
The corner near the power supply needs to be slightly smaller so that's the oddball.
The other 3 corners are the same.
The print model is for all 4 corners, but when I started installing them, I found 3 corners were sufficient so I didn't bother with the fourth.
This leaves all of the vents & ports clear, including the reset hole.
It also keeps a small space between the plywood and the bottom of the unit.
Installation
You'll need 4 screws (3 if you only use 3 corners) with a pan/wafer/flat head.
I used sheet metal screws because they were handy: #8 x 3/4in wafer head.
I'm sure there are other ways to do this, but I held the unit up with the bottom left (the short corner near the power supply) to the board then screwed in the screw. Then I slid the other bottom corner in place, levelled it, and screwed in.
It actually holds with just the bottom 2, but I wasn't comfortable leaving it that way. So slide on the top corners in place snuggly and drive in the screw.
Printing
I didn't use any supports, but I did end up with some delamination for a couple of the passes in the curve. Figured I didn't care that much.