Sound Voltex Nemsys Monitor Stand for LG 32GN500, 32GN500-B, 32GN50T, 32GN50R, 32GN600, 32GN600-B
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Printable stand for all 32GN500 and 32GN600 type monitors for Sound Voltex Nemsys cabs.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 204
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
Don't have a 3D printer? Email me at [email protected] and I'll print for $70+shipping
Tested and confirmed working for LG 32GN600-B Works for 32GN500, 32GN500-B, 32GN50T, 32GN50R, 32GN600.
Please read the instruction manual before printing this to ensure you have all the materials to install this mount.
NEW: 250x250x250mm model has been released
If i saved you hours of work, please consider sending me a coffee (or more) here:
Current Problems To Be Fixed
Poor cable management as requires sacrificing other cable holders to fit this mount
Monitor does not clamp in place to prevent falling out when taking out front panel; this can lead to damage if not handled correctly
Chamfers on some parts of the model to reduce filament
Tighten the dovetail connections a little more, and have AA/AB parts slide in a few layers further (low-priority)
Bill of Materials
8 M4x20mm
4 M4x20mm hex screws (may use any type, but it will be more difficult to insert. See step 9)
4 M6x20mm
Printed on Creality K2 Plus (350x350x350mm), have not tested the smaller models but the 3mf/gcode file included should be good
I'll try to make smaller models in the near future
Given the structural integrity of PLA/PETG, it is not recommended to make a 3d printed mount in the style of a VESA mount. Plastic will bend and break, so its better to utilize it as a bottom stand.
If you have any issues with the print please reach out to me at [email protected]
Thank you!