Rumble Jig for Finding the Strong Rumble 3

In Nintendo Switch 2 Welcome Tour, the final medal in the minigame Finding the Strong Rumble 3 wants extreme precision, which I personally just couldn't do as I found it very difficult to recognizing the small differences between the rumble strengths. As a completionism, I just couldn't let this go nor could I be satisfied with landing a score of 2, when the required for the medal was 1 or 0.

Fed up with failed attempt after failed attempt, I decided to create this assist tool to help. It doesn't completely take out the guesswork, it just allows you to help measure about where the center should be. You still need to figure out where the perimeter of the strongest rumble radius is and alight the tool accordingly. With this version of the tool it took me about 4 attempts to find the center.

For print settings, I just used the standard DRAFT settings for my filament, PLA in this case.

How to Use

1. Search around to find where you think somewhere near the strongest rumble point is and place the jig for the center around that area.

2. Search around the edges until you find zones that do not produce any rumble. Careful to take into consideration where there might be overlap from false positives, you want no rumble at all areas outside the strong point radius.

3. Alight the jig so that when your cursor is inside the circle you feel a rumble, and when it is on or outside the circle you do not.

4. Repeat Step 3 for as many alignment points as you can to have the most accurate jig placement.

5. Place the cursor in the center and check your score!

Good Luck!