1 Inch Plunger Tube Extension
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
1 Inch Extension for 1.5 inch OD 1.375 inch ID Tube. This is not meant to be air tight.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 46
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
When building the Excalibur by Sillybutts it has a section of plunger tube at the rear purely for decorative purposes. I had a scrap of plunger tube that was about an inch short and so I decided to make a spacer so I could use the scrap piece and figured I'd throw it up here in case anyone else needs it for something. It's not meant to be airtight.
The first file labeled outer is the same dimensions as a plunger tube and has two tabs that center it on the outside. This fits in either the front or rear of the decorative piece of plunger tube at the rear part of Excalibur perfectly.
The file labeled inner has a rim that slides into the plunger tube; this did not work on the Excalibur due to the size of the spring plug and the plunger itself being nearly the full ID of the plunger tube. I put it up here in case someone needs it for something.
I printed them in PETG and added walls until they were solid. I suspect you could use whatever filament you wanted since there really isn't any stress on this piece.