DeWalt 20v Battery Adapter Mount Plate for 45 Degree Fit - goBilda / FTC Robotics
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Flat and 45° mounts for common aftermarket DeWalt 20v battery adapters, for powering 12v FTC Robots and similar uses.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 95
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
These are obviously not competition legal, but I find them useful for practice. Using a 20V DeWalt battery with a 12v buck converter can give some other battery management options.
NOTE: Lithium batteries must not be discharged below about 2.8v (14v as deployed in parallel by DeWalt). The aftermarket adapter recommended in the BOM below includes an auto-cut-off in the Buck Converter. Not all have this, so be sure you only use ones that do.
The 45 degree mount feels a little oversized. But it was made to secure the big 8AH batteries in an awkward position (pictured). I downsized the flat one, but still left a minimum of 5mm of plastic for strength. You and your mentors are solely responsible for evaluating the safety of any use case for this part or the devices it attaches to. If this isn't safe for your use case, don't use it!
Consider the location of your battery given your use case. The big battery photo here is for a rocket launcher (half disassembled in the photo). This device will never be driven in competition, and will only be used in a carefully staged bit of rocket launch theater. So placement in front works.
However, for FTC practice bots that may collide with each other, the battery should be shielded by thick aluminum frame, usually internal to the frame. Do not put these batteries where they might be punctured during use. In all cases, you and your mentors are solely responsible for evaluating the safety of any use case for this part or the devices it attaches to.
Print as a structural part. The specs from Voron are a good start: https://docs.vorondesign.com/sourcing.html#print-settings.
But also consider the weight of your batteries when printing. Print with 80% to 90% cubic infill if max strength is required. That adds only 30 minutes and 25 grams to the flat print. But remember: You and your mentors are solely responsible for evaluating the safety of any use case for this part or the devices it attaches to.
BOM:
DeWalt Adapter with 12v Buck Converter (includes low-voltage cut-off): https://amzn.to/43UOIDt
Filament:
PLA+: https://amzn.to/3MjaRpN
PETG: https://amzn.to/4a0Bqd3
SUPPORTING YOUR FAVORITE DESIGNERS:
Please like, download, follow and/or use the affiliate links under 'BOM' to support my work and encourage more of it.