SMA bushing adapter for DL2MAN's MOXON antenna
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
SMA connector bushing to add to the 2m Moxon feedpoint to allow for a SMA jumper to connect the two to one radio.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 111
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
I wanted to join the 2m and 70cm segments together so that I could hold the antenna like a dual band handheld antenna. I cut the chamfer off of the pole adapter in my slicer and glued it onto another pole adapter so to make it long enough to connect the two antenna segments to the same center point. Then I soldered another SMA adapter to the BNC in the tip of the 2m pole. That's where this bushing I made comes in. It secures the new SMA adapter and now just make a SMA jumper wire between the two. I haven't tried it yet, but the hardware is done.