Overture Refill Spool - Full Plastic
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A spool for using the Overture3D filament rolls that don't have sides.
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 142
- Wydruki
- 2
- Wyświetlenia
- 364
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Filament is expensive, so we want to be as cost effective as we can. Overture sells refill spools that don't have sides, so I wanted to be able to use these (every buck or two saved helps!).
I looked at and even tried various models and didn't really see one that I liked, so I started from scratch (and I enjoy problem solving).
This one is complete with hex-gridded sides. It also has the registration notch for the refill roll.
I've only tried this with Overture refills, so I only know it works on them. But likely won't fit others, since I'm guessing it would be too much to ask the mfgrs to standardize.
Each side takes a while to print on an MK3S+ AND it uses lots of filament, so while this is totally usable (and would print faster on other machines), it's a slog. But they work and have been solid so far.
This was my first version. In the interest of saving resources and leveraging throw-away material, I did another version that reuses the sides from Overture's non-refill spools.
SEE: https://www.printables.com/model/1750582-overture-refill-spool-cardboard-side-reuse