1 / 2
DIY Electric Kayak/SUP Motor Kit & Fin Mount - 800W & 2800W E-Board Conversion — zdjęcie 1
1 / 2

DIY Electric Kayak/SUP Motor Kit & Fin Mount - 800W & 2800W E-Board Conversion

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Budget DIY electric kayak/paddleboard kit. Slow speeds for long runtime, or fast speeds with less runtime. Great value!

Ocena
0 / 5
Polubienia
1
Pobrania
16
Wydruki
0
Wyświetlenia
328
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Standard Digital File License

This model comes in two versions; both share the same core but feature different fin designs for two separate motors. I highly recommend printing with ASA for its strength and UV resistance. For the throttle, a simple servo tester or an RC transmitter/receiver will work. I plan to make a custom throttle box / battery box later using a potentiometer and a microcontroller to add a reverse feature. Right now, it is designed so you can add a new fin and glue it on with a waterproof, slightly flexible epoxy. I can also model a new design to fit your current kayak or paddleboard for an additional charge.

First Design Specs(800w):

  • Motor: 800W

  • Battery: 24V (Minimum 35A continuous current). This 6S LiPo works great if a long runtime isn't required. If you want more run time you can always use a 50ah LiFePO4 

  • Hardware: 4x M3x4x5 threaded inserts (required for this fin model). You will also need M3 bolts and washer depending on your kit.

  • ESC Note: Purchasing the motor bundled with a paired ESC is highly recommended, as it is much cheaper than buying a separate ESC.

Second Design Specs (2,800W):

  • Motor: 2,800W (Targeted for high speed, shorter runtime).

  • Speed Controller: 

  • Battery: 12S–16S LiPo. (Recommended setup: Four 4S 10Ah LiPo batteries wired in series for a 16S configuration).

  • Hardware: No threaded inserts required. Uses M4x12mm bolts.

  • Cooling: You should use some type of water cooling for this setup because of the high power output in an enclosed space without airflow.

If you want me to print and assemble the kits email me at [email protected]

 800W Kit: (Motor, ESC, battery, charger, printed parts, and throttle/battery box) = $420 + Shiping

2800W Kit (NO BATTERY): (Motor, ESC, printed parts, and throttle box) = $440 + Shiping

Tagi