Filtered Door for 8-Bay Mini Rack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Door/cover for a 3U 8 Drive Bay Mini Rack
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 46
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
DISCLAIMER: I AM BORED SO I AM UPLOADING THIS BEFORE TESTING PRINT!
If there are any issues with your prints and you either can't fix them or don't want to, please notify me in the comments or a message and I will try to address it.
I have done it again, modified one of @RagingRoosevelt's models. Please get the mounts and handles from his model as they are unmodified in this version.
This model is designed to be used with my version of the 8-Bay Rack as it has fans in the back of it and the main purpose is airflow. The vents are bigger and I added a removable dust filter for easy cleaning.
The carrier should be paused around layer 6 or 7 when using a 0.2mm layer height. Once the print is paused you can place and secure your filter material. I used a nylon filter found here: https://www.amazon.com/dp/B0GPX74QTD After that you can resume print.
Printing Orientation should be flat on both parts.
Supports are necessary on only the door model where the slot for the carrier is.
Tolerance is 0.3mm
Filament should be fine as PLA.