Zwift Ride Setback adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For all that have problems with the large setback of the Zwift Ride frame.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 336
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Indoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
You need one M8 and M6 screws for higher stability.
Printed in PETG with 4 outer walls and 5 top an bottom layers and 40% cubic infill.
Just mirrow the part in your slicer to have both sides. I printed it laying flat in order to have better stability in at the holes.
NOTE: When you tight the M8 screw there will be a crack, because of the press fit. I'm still searching for the right tolerance. But since I'm 180cm with 80kg and did also short 600W intervalls on the saddle without problems I want to share this part for all that have the setback problem on zwift ride.
UPDATE (18.06.2026): The crack appears between the layers because the tension at the screw is quite high. I recommend in such cases taking a longer M8 screw with a biq washer to clamp it from the very outside (see 2nd picture), so the part shouldn't crack between the layers. I also created Version 2 (_V2). It has little more material so I hope it's more stable.