Frame for Arylic Window For Snapmaker U1 Sterilite/Samla/Storage Box Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Acrylic window for the Sterilite cover that I was using as it's tough to see through the cover.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 195
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
Be sure to read the print instructions.
I wanted a window as it's tough to see through the Sterilite box. I upload 2 stl's. One is 260x260, for the front and/or the sides, and the other is 260x240 as that would fit the top of the sterilite better. They are made for 2.5mm thick acrylic. I also included the fusion f3d file in case you want to make changes yourself. There are 3 parameters that are favorited in 'change parameters' for the width/length and the thickness of the glass. I also didn't like the ones I found as you can see the screws on them. This one looks a lot cleaner.
To print it, you will need to add a pause before it prints the corners that hold the acrylic in place. The dimensions for the acryilic would be 20mm smaller than the dimensions for the entire frame. Then you put down the acryilic and continue, and it will print on it and hold it in place. Then, you can add heat set inserts on the back.I only put some in the corners, but I added a bunch more holes in case you want to add more screws.
Cut out the hole in the box. I used an oscillating multitool to cut both the acrylic and the box. The hole should be around the same size as the acryilic. Next lay the frame where you want it and mark the holes for the screws on the other side. I used a drill for the holes.
A deburring tool is also usefule to clean things up.