Destiny 2 - Turncoat [Of Two Minds]
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bring Turncoat w/ Of Two Minds Ornament from Destiny 2 to your collection with this replica model!
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 81
- Wydruki
- 0
- Wyświetlenia
- 361
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Sculptures
- Licencja
- Creative Commons — Public Domain
Destiny 2 - Turncoat [Of Two Minds]
Bring Turncoat w/ Of Two Minds Ornament from Destiny 2 to your collection with this replica model!
This upload includes multiple file formats so you can either print immediately using the included profile or make your own adjustments depending on your machine and preferences.
(As far as I’m aware, this is currently the only printable version of Turncoat available. I put a lot of time into recreating and preparing it for printing, so if you enjoy the model, a rating, make, follow, or a quick thank you is always appreciated.)
Included Files
STL files – separated and ready for slicing
BLEND file – editable source file for scaling, modifications, or custom prep
3MF project file – includes my recommended print settings and layout
Pre-oriented parts where applicable for cleaner printing and easier assembly
Recommended Print Settings
(These are the settings used for the preview print — adjust as needed for your machine and filament.)
Printer Type: FDM
Layer Height: 0.20 mm
Initial Layer: 0.24 mm
Walls: 2
Top / Bottom Layers: 3
Infill: 5–8% Gyroid or Cross Hatch
Supports: Yes – build plate only where possible
Brim: Recommended 7-10mm
Nozzle: 0.4 mm
Material: Silk PLA+ / PLA+ recommended
Print Notes
Printer: FlashForge AD5X
Parts have been split to reduce support use and improve surface quality.
Dry fit all pieces before gluing (Some required a little heating with a lighter to adjust tolerances)
Sanding, filler primer, and paint will give the best final finish. (I used acrylic paint markers)
Scale can be adjusted in slicer if required (As I think mine was about 10% too small)
Included 3MF contains my setup as a starting point but results may vary between printers.
Assembly
Clean support contact points before assembly.
Use CA glue or your preferred plastic-safe adhesive.
Test alignment before final bonding.
Disclaimer
This is a fan-made recreation inspired by Destiny 2 intended for personal use, display, and cosplay purposes. I do not own the original design rights to Destiny or its associated assets.