Vessel IMPACT BALL Torsion Bit 30+1 PC. Set in SLIDE CASE Holder for IKEA SKÅDIS (T-Nut Mount)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A holder for the Vessel IMPACT BALL Torsion Bit 30+1 PC. Set in SLIDE CASE Holder for IKEA SKÅDIS (T-Nut Mount)
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 97
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
Vessel IMPACT BALL Torsion Bit 30+1 PC. Set in SLIDE CASE Holder for IKEA SKÅDIS (T-Nut Mount)
A holder for Vessel's IMPACT BALL Torsion Bit 30+1 PC. Set (No. IB31P02U). Designed to mount on an IKEA SKÅDIS pegboard using 6d6178's SKÅDIS T-Nuts mounting system. No fragile printed hooks requiring supports. The mounting holes and alignment guides are built in; you supply the screws and nuts. The fit should be snug but easy to remove and replace.
Required Hardware
You'll need to print the T-Nuts separately from that model and supply standard hardware. Per mounting point:
1× printed T-Nut (M2.5 version)
1× M2.5 DIN934 hex nut
1× M2.5 socket head cap screw (length below)
This part has 4 mounting points, so multiply accordingly.
Screw length: For this part, use a screw around 12-16mm long — round to the nearest size you have on hand. Shorter is fine as long as it threads fully into the nut; longer risks bottoming against the wall behind the board.
Printing
PLA, PETG, anything will work
Layer height: 0.2 mm
Standard infill works fine
Print the T-Nuts from the linked model at the same time.
Installation
Seat a hex nut into each printed T-Nut (a dab of superglue if the fit is loose).
Push a screw through the mounting hole in this part.
Thread the T-Nut on until there's a 1–4 mm gap between it and the part — it should still rotate freely.
Insert the T-Nut through a SKÅDIS peg hole in the vertical orientation.
Tighten the screw. The T-Nut rotates and locks horizontal, clamping the part to the board.
Snug, don't crank — over-tightening can stress the print or the pegboard.
Repeat for each mounting point. To remove, loosen until the T-Nut returns to vertical and pull straight out.
Full T-Nut documentation, BOM, and design guidance: SKÅDIS T-Nuts Mounting System by 6d6178.