1 / 2
Vessel IMPACT BALL Torsion Bit 30+1 PC. Set in SLIDE CASE Holder for IKEA SKÅDIS (T-Nut Mount) — image 1
1 / 2

Vessel IMPACT BALL Torsion Bit 30+1 PC. Set in SLIDE CASE Holder for IKEA SKÅDIS (T-Nut Mount)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A holder for the Vessel IMPACT BALL Torsion Bit 30+1 PC. Set in SLIDE CASE Holder for IKEA SKÅDIS (T-Nut Mount)

Rating
0 / 5
Likes
0
Downloads
7
Makes
0
Views
94
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Public Domain

Vessel IMPACT BALL Torsion Bit 30+1 PC. Set in SLIDE CASE Holder for IKEA SKÅDIS (T-Nut Mount)

A holder for Vessel's IMPACT BALL Torsion Bit 30+1 PC. Set (No. IB31P02U). Designed to mount on an IKEA SKÅDIS pegboard using 6d6178's SKÅDIS T-Nuts mounting system. No fragile printed hooks requiring supports. The mounting holes and alignment guides are built in; you supply the screws and nuts. The fit should be snug but easy to remove and replace.

Required Hardware

You'll need to print the T-Nuts separately from that model and supply standard hardware. Per mounting point:

  • 1× printed T-Nut (M2.5 version)

  • 1× M2.5 DIN934 hex nut

  • 1× M2.5 socket head cap screw (length below)

This part has 4 mounting points, so multiply accordingly.

Screw length: For this part, use a screw around 12-16mm long — round to the nearest size you have on hand. Shorter is fine as long as it threads fully into the nut; longer risks bottoming against the wall behind the board.

Printing

  • PLA, PETG, anything will work

  • Layer height: 0.2 mm

  • Standard infill works fine

  • Print the T-Nuts from the linked model at the same time.

Installation

  1. Seat a hex nut into each printed T-Nut (a dab of superglue if the fit is loose).

  2. Push a screw through the mounting hole in this part.

  3. Thread the T-Nut on until there's a 1–4 mm gap between it and the part — it should still rotate freely.

  4. Insert the T-Nut through a SKÅDIS peg hole in the vertical orientation.

  5. Tighten the screw. The T-Nut rotates and locks horizontal, clamping the part to the board.

  6. Snug, don't crank — over-tightening can stress the print or the pegboard.

Repeat for each mounting point. To remove, loosen until the T-Nut returns to vertical and pull straight out.

Full T-Nut documentation, BOM, and design guidance: SKÅDIS T-Nuts Mounting System by 6d6178.

Tags