Spool Holder Knob Extension for Qidi Q2 (or similar spool-holders)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This part helps prevent the spool from slipping off the holder while also making knob easiar to grip and handle
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 82
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
The extension is designed so that the original spool holder knob fits tightly inside it, meaning the stock part remains fully usable rather than sitting unused in a drawer.
Once installed, it provides more secure spool retention and reduces the chance of the spool accidentally coming off the holder. The larger diameter also makes tightening and removing the knob much more comfortable.
Convenient finger cutouts allow the original knob to be easily pushed out using your thumbs whenever needed.
Printing Instructions:
Any rigid filament material will work.
Print with the flat side on the build plate.
Enable supports from build plate only, and only for the base section (no supports inside the inner part, as shown on picture).
The upper part prints well without supports; adding supports there, could make them hard to remove.3–4 perimeters/walls and 10% infill are enough.
I recommend using Outer/Inner wall order (outside-to-inside), as the tolerances are fairly tight.
If you run into any issues, please let me know and I'll do my best to help.