1 / 2
7x25mm ERM (Vibration) Motor Enclosure — zdjęcie 1
1 / 2

7x25mm ERM (Vibration) Motor Enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An enclosure to protect the thin wires of a 7x25mm ERM motor

Ocena
0 / 5
Polubienia
1
Pobrania
8
Wydruki
0
Wyświetlenia
53
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

An enclosure to protect the thin wires of 7x25mm ERM motors that can be found here:
https://www.amazon.com/Vibration-Vibrating-8000-20000RPM-Electronic-equipments/dp/B0GVFDYX8T

I am using 40 of these to make a DIY tactic vest utilizing SenseShift here: https://github.com/senseshift/senseshift-hardware

The wires can be tied into a knot close to the ERM, then fed through the 2mm hole at the end of the enclosure.  The enclosure can snap together and be fitted to a vest using zip ties in the two channels on each end.  The middle channel is the proper size to fit a velcro tie, if preferred.

Tagi