7x25mm ERM (Vibration) Motor Enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An enclosure to protect the thin wires of a 7x25mm ERM motor
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 8
- Makes
- 0
- Views
- 54
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Virtual Reality
- License
- Creative Commons — Public Domain
An enclosure to protect the thin wires of 7x25mm ERM motors that can be found here:
https://www.amazon.com/Vibration-Vibrating-8000-20000RPM-Electronic-equipments/dp/B0GVFDYX8T
I am using 40 of these to make a DIY tactic vest utilizing SenseShift here: https://github.com/senseshift/senseshift-hardware
The wires can be tied into a knot close to the ERM, then fed through the 2mm hole at the end of the enclosure. The enclosure can snap together and be fitted to a vest using zip ties in the two channels on each end. The middle channel is the proper size to fit a velcro tie, if preferred.
