1 / 7
Gardena Spreader/Streuwagen 300-430 (2017)  Overhaul drive train — zdjęcie 1
1 / 7

Gardena Spreader/Streuwagen 300-430 (2017) Overhaul drive train

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

260611 Gardena Streuwagen 300-430 (2017)The Gardena 300-430 has a serious flaw ;-( and is basically not…

Ocena
0 / 5
Polubienia
0
Pobrania
2
Wydruki
0
Wyświetlenia
38
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

260611 Gardena Streuwagen 300-430 (2017)

The Gardena 300-430 has a serious flaw ;-( and is basically not repairable.

After a couple of years (2-3) the wheels are starting to turn with a heavy resistance until it does not rotate anymore on friction. A couple years ago I submerged it in hot water to see if this had an impact. Resistance got a little lower, but it did not function properly. Recently I had some time on my hands and started dismanteling it.

See picture of Gardena for explanation:

  • Wheel assy 8/10 and 13/14 have an integrated one way clutch (quite clever).
  • 8 and 14 are connected to tube 4 (square 14x1 mm), left and right wheel is mirrored.
  • 8 bears in 10 and 10 bears in the throgh 5.
  • Important!:8 is clipped into 4 with a non reversable click (tube 4 has lips punched downward --> one time assy !). So dismanteling a wheel will distroy the connection between wheel assy 8/10 and tube 4. For the result see pictures.
  • In my case tube 4 was heavily corroded by the fertilizer, so tube was useless anyway.

Reason for friction is fertilizer built up in bearing 11/12 !.

When taken apart you will see that 8/13 has a metal "bolt" inside. In order to disassemble 8/10 the best way I found is put the bearing part in a cup of hot water (90C/200F). Then first punch the metal bolt out and then gently push out part 8. 10 has a small ridge, and 8 has a cavity !.

Repair materials: -- Wheel Left and Right (print from files) -- Philips screws (2x) connical head approx 6x80 mm -- tube 15x15x1 mm length is silicone (3) + 4mm -- grease

Assy: -- clean the bearings 11 and 12 (scrape with hobby knife) and grease -- debur the edges of the new tube 4 -- put silicone 3 in hot water -- pull 3 over 4, so it is in the middle -- grease 10/8 and 13/14 and assemble -- mount screw 6x80 left and right

Now the "Streuwagen" can be disassembled for maintenance !! and will last a lifetime ;-)

Print settings 0,2 mm layer, infill 30%, material PETG. Orientation is shaft up, as on pictures.

Please like, follow and return your comments.

Feel free to donate, thank you.

Category: Sport & Outdoors

Tagi