1 / 4
Gyro Manta Battle Tops - 3 Blades + Ripcord Launcher — zdjęcie 1
1 / 4

Gyro Manta Battle Tops - 3 Blades + Ripcord Launcher

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Three swappable battle tops with a shared base, power launcher, and deep-engage ripcord for Open Sauce.

Ocena
0 / 5
Polubienia
5
Pobrania
33
Wydruki
0
Wyświetlenia
202
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Gyro Manta is a fully 3D printable battle top set with three swappable tops, one shared base, one launcher, and one deep-engage ripcord.

The set includes one shared threaded base, one power launcher, one ripcord, and three swappable upper bodies with different battle styles.

All three variants have been tested to spin for at least 120 seconds when printed and launched properly.

The tops use a two-part body design. The shared base screws into the selected upper body. Each upper body is printed as one solid part with the blade shape, launcher gear, and internal thread already combined, so there is no loose blade stack to clamp or fall out.

Why This Design
Three distinct battle styles in one upload
Shared base for all three tops
Shared power launcher and ripcord
Deep-engage ripcord for better gear contact
Left-hand thread for assembly
Fully plastic and 3D printable
Designed for arena battle use
Tested spin time of at least 120 seconds for all three variants

Variant Guide

Variant

Use it when...

Character

Balanced Manta

You want one safe battle pick

Good spin, good bite, predictable behavior

Stamina Halo

You want longest spin or defense

Smooth edge, strong spin retention

Attack Hook

You want aggressive hits

Strongest edge bite, shorter endurance

Specs
Blade contact height: 25 mm
Max blade diameter: 90.8 mm
Ripcord length: 270 mm
Material: plastic only
Launcher: printed plastic
Thread: left-hand

Recommended Print Settings
Material: PETG for durability, PLA+ for stiffness
Infill: 80-100%
Walls: 5-6
Layer height: 0.16-0.20 mm
Supports: none expected

Print Orientation
Base: print upright with a brim
Uppers: print flat on the blade face
Ripcord: print flat
Launcher: print flat

For the strongest battle setup, print the base and Attack Hook at 100% infill. For lighter and faster prints, 80% infill works well, especially for Stamina Halo.

Assembly Instructions
Pick one upper body: Balanced Manta, Stamina Halo, or Attack Hook.
Screw the shared base into the selected upper body.
The thread is left-hand, so it tightens opposite to a normal screw.
Insert the ripcord with the tooth side facing the gear.
Place the assembled top into the launcher.
Pull straight and hard.

Fit Instructions
If the thread feels tight, gently deburr the first thread turn. Do not force it.
If your printer makes holes tight, scale only the upper body in XY to 100.4-100.7%.
Do not scale the launcher or ripcord unless you are intentionally tuning the fit.

PETG is better for impact toughness. PLA+ gives crisp launches but may chip sooner during hard impacts.

Post your makes, spin times, and battle damage photos. I want to see which variant survives the arena best.

Tagi