1 / 3
Woom bike mudguard to Followme adapter — zdjęcie 1
1 / 3

Woom bike mudguard to Followme adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

It is an adapter between the FollowMe bolt and the Woom bike mudguard clamp.

Ocena
0 / 5
Polubienia
0
Pobrania
3
Wydruki
0
Wyświetlenia
59
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I installed the FollowMe on a Woom 4 that has a mudguard. The mudguard clamp no longer had a place to attach, and the FollowMe bolt was too small, so I 3D-printed an adapter sleeve. You have to be a bit careful when sliding it on so you don't snap off the rim. I printed it using PETG, but if you have an even stronger material available, use that instead. Prusament PC Blend Carbon Fiber would be a good choice, though it is expensive.

Tagi