1 / 3
Convert Thule t-bolt to strut channel: a t-bolt carrier — zdjęcie 1
1 / 3

Convert Thule t-bolt to strut channel: a t-bolt carrier

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I made a roof rack out of narrow-profile unistrut (strut channel, superstrut...) and wanted to mount a modern Thule…

Ocena
0 / 5
Polubienia
1
Pobrania
3
Wydruki
0
Wyświetlenia
30
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

I made a roof rack out of narrow-profile unistrut (strut channel, superstrut...) and wanted to mount a modern Thule bike rack to it. I made these little carriers (which press-fit on the t-bolt, but I also used CA glue) to hold the t-bolt up as high as possible (so it is easy to engage the tightening handle) and prevent it from turning when the rack is tightened down. The head of the t-bolt goes into the cavity on the carrier. I didn't make one for full-profile unistrut, but could do so if there was interest. Benefits of using the t-bolts rather than the under-the-cross-bar brackets is that it is easier and faster to install the bike rack, the t-bolts, unlike the brackets, don't fall off of the rack, it is a cleaner design, and you don't risk dropping the metal brackets on the roof of your vehicle. You can install the bike rack (e.g. the TopRide) in about 1 minute.

I printed this out of ASA for outdoor use, but PETG or many other filaments should work.

Category: Household

Tagi