Convert Thule t-bolt to strut channel: a t-bolt carrier
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I made a roof rack out of narrow-profile unistrut (strut channel, superstrut...) and wanted to mount a modern Thule…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 3
- Makes
- 0
- Views
- 30
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
I made a roof rack out of narrow-profile unistrut (strut channel, superstrut...) and wanted to mount a modern Thule bike rack to it. I made these little carriers (which press-fit on the t-bolt, but I also used CA glue) to hold the t-bolt up as high as possible (so it is easy to engage the tightening handle) and prevent it from turning when the rack is tightened down. The head of the t-bolt goes into the cavity on the carrier. I didn't make one for full-profile unistrut, but could do so if there was interest. Benefits of using the t-bolts rather than the under-the-cross-bar brackets is that it is easier and faster to install the bike rack, the t-bolts, unlike the brackets, don't fall off of the rack, it is a cleaner design, and you don't risk dropping the metal brackets on the roof of your vehicle. You can install the bike rack (e.g. the TopRide) in about 1 minute.
I printed this out of ASA for outdoor use, but PETG or many other filaments should work.
Category: Household