MJK Hyper Go 14303 Interior Protection Cover

Whilst this cover is not "waterproof", I was unhappy with the flimsy stock cover as I felt it left too much exposed. I also needed to replace the RX and fit the MJK 3rd party RX light controller and wanted more space under the cover so I designed this one.

Its a good fit*, the clearance between the front wheels and the cover at full steering lock is tight, but there's clearance.  The dome covers the RX inputs and allows for the light controller to be mounted on the bar at the rear. I've left a cutout for a servo extension cable exiting the rear for connection to the car body lights.

*Whilst mine fits like a glove, its possible your ESC fan (if you fitted it) and/or motor fan is not quite in the same place as mine so your mileage might vary, I'd be interested to hear feedback on this.

I've found the best orientation for printing is as per the image, gives the best quality whilst balancing the amount of support filament required. Around 77g for the model and around +17g of supports.

Given how hot the ESC gets running 3S, I'd suggest not printing in PLA and instead choose a filament that can handle more heat, my go-to is PETG.

Of course, there are a couple of drawbacks, with the flimsy stock cover, its easy to turn the ESC on without removing the cover, that's not possible with this one, perhaps when time permits I will solve that.