1 / 14
Q1 Pro Remix + EBB36 GEN2 + A1/H2D Hotend + MMU HUB + Post-Extruder Cutter — zdjęcie 1
1 / 14

Q1 Pro Remix + EBB36 GEN2 + A1/H2D Hotend + MMU HUB + Post-Extruder Cutter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Q1 Pro mix of remixed design's to fit my needs and try new things.

Ocena
0 / 5
Polubienia
7
Pobrania
21
Wydruki
0
Wyświetlenia
251
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

My Q1P pro toolhead board was becoming finnicky. Instead of replacing, decided to use some EBB GEN2's I had laying around.

Thank you to the original model designers.

I will try to update this with screws/inserts needed. For most parts, I reused screws from the originals.

Update 10/4: Added multicolor print

Update 9/17: Transitioned to a new fan duct. no longer using a cover as i adapted a new fan duct to my Q1P. 

Fused this model with my extruder/heatsink fan holder to improve overall rigidity on my Q1P


Additionally, assembled my cutter:

this uses a trimmed Bambu Filament Cutter Replacement Blade (can be found on Ali,Amazon). secured with a m2 screw and m2 heat insert. to be tested soon.

Update 6/19: Fixed collision of Cutter and Front Cover. Models adjusted to work together.

To Print the Toolhead Base:

the top edge is chamfered to provide a face to place on build plate. depending on your layer adhesion and bridging/overhang printing, you could print with out supports. minimal are required.