XLPower Stratos 200 Antenna Mounts (Nexus XR and Vbar Evo)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An antenna mount to keep the nexus xr and vbar antennas neat and tidy.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 57
- Wydruki
- 0
- Wyświetlenia
- 266
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Introducing the Stratos 200 Antenna Mounts by WrightFpv.
This is a clean, durable, and lightweight antenna mounting solution designed specifically for the XLPower Stratos 200 helicopter, compatible with both the RadioMaster Nexus XR and VBar flight controllers.
This two-part system is designed to keep your antenna layout clean and tidy, routing the antenna leads perfectly while maintaining the heli's sleek aesthetic.
🛠 Mounting Configuration
This setup utilizes a two-part layout to achieve a neat and tidy setup for your receiver antennas:
Under-Servo Antenna Mount: Installs directly underneath the servo plugs of the Nexus XR flight controller unit.
Rear Antenna Holder: Mounts toward the back of the frame to hold and route the antenna.
🔧 Installation Instructions
Secure the mounts with some double-sided tape. See the images below for exactly where to install:
Front Antenna Mount

Rear Antenna Mount

🖨 Print Settings & Sizing Recommendations
To accommodate different printer tolerances, filament expansion, or various antenna thicknesses, the main antenna mount is provided in three antenna tube inner-diameter sizes:
1.50mm Version: Provides a tighter, snug friction fit.
1.55mm Version: Provides a standard, medium fit.
1.60mm Version: Provides a slightly looser fit.
💡 I have included the original .STEP files in the download section. If none of these sizes perfectly match your specific antenna or printer calibration, feel free to pull the step files into your CAD software of choice and easily adjust them to your exact needs!
Recommended Print Settings:
I highly recommend using a flexible filament:
Material: TPU
Infill: 50%
Perimeters/Walls: 2 or 3
Orientation: These parts are designed to be printed upright.
Supports:
Short Mounts & Under-Servo Mount: No supports needed when printed upright.
Rear Antenna Holder: Requires supports to print cleanly.
Don't forget to check out my other designs—including the XLPower Stratos 200 Toolless Battery Spacer—on my Printables profile!