1 / 8
Vintage Reproduction Art Deco Electrical Covers — zdjęcie 1
1 / 8

Vintage Reproduction Art Deco Electrical Covers

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Printable US standard lightswitch and double outlet covers +screw covers via a reproduced vintage art deco outlet cover

Ocena
5 / 5
Polubienia
136
Pobrania
158
Wydruki
1
Wyświetlenia
1327
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution — Noncommercial

I reproduced a vintage bakelite art deco outlet cover.  I modified this file to be printable and into a US standard lightswitch cover and a US standard double outlet cover (complete with back ribbing).  In order to reproduce the stylized screws of the original, I created caps that you can place over standard screws.

Files:

  • ReproductionOutlet - this is the digital model reproduction of the original outlet cover.  It is not optimized for 3D printing (via FFF) nor does it qualify for modern standard US outlets.

  • Lightswitch - US standard single light switch cover using the reproduction as the base plus modified to not be horrible for FFF 3D printing.  - Requires support and guards against warping

    • Included in the .3MF file

  • USDoubleOutlet - US standard double outlet cover using the reproduction as the base plus modified to not be horrible for FFF 3D printing. - Requires support and guards against warping

  • ScrewCap - Will cap the screw port after the covers are installed to mimic the visual effect of using the original stylized screws.  Two are needed for the lightcover and only one for the outlet.  - Does NOT require support

    • Included in the .3MF file

  • .3MF file is for printing the lightcover and two screw caps in Silk PLA on a Bambu Carbon X1 at 0.28 mm.  Support is already generated where needed.  Stylized top infill pattern used.  Was used to print the lightcovers pictured.

Successfully printed in PLA and silk PLA at 0.28 mm layer height on a Bambo Carbon X1 - Screw caps also successfully printed at 0.12 mm layer height

Tagi