8 inch Vent Partial Redirector (AC / Heat Pump / Wall or Ceiling Duct)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clip onto the end of an 8" to block air flow to part of the room. Especially when bed is getting blasted with AC air
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 34
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution
This is a simple model made to clip on to the round cover of the wall or ceiling duct vent. In my case the diameter of that cover was 6.75", but the model should be fairly flexible to accommodate slight variations in sizes.
I have two designs: one with a 1.75" long cover portion and covering 90 degrees of the ventilation perimeter, and another with a 2.25" long cover extending to 135 degrees of the ventilation perimeter.
Print in PETG or better for longevity, especially if used with a heating vent as PLA is likely to deform over time.