8 inch Vent Partial Redirector (AC / Heat Pump / Wall or Ceiling Duct)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Clip onto the end of an 8" to block air flow to part of the room. Especially when bed is getting blasted with AC air
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 2
- Makes
- 0
- Views
- 34
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bedroom
- License
- Creative Commons — Attribution
This is a simple model made to clip on to the round cover of the wall or ceiling duct vent. In my case the diameter of that cover was 6.75", but the model should be fairly flexible to accommodate slight variations in sizes.
I have two designs: one with a 1.75" long cover portion and covering 90 degrees of the ventilation perimeter, and another with a 2.25" long cover extending to 135 degrees of the ventilation perimeter.
Print in PETG or better for longevity, especially if used with a heating vent as PLA is likely to deform over time.