Mid-Century Modern Decorator Wallplates
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Trapezoid Decorator wallplates for 1, 2, 3, and 4 Gang switches.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 103
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution
This is a trapezoid shaped wallplate for North American decorator switches/outlets. It feels fairly mid-century and is a fun addition to a house or room. The rounded edges struggle as overhangs, so I recommend printing it face-up with supports for the whole underside. It does use more filament but as a primarily cosmetic design, I think it's worth the extra filament.
NOTE: Normally the screws come with the wall plate, so you can either reuse old ones or buy them separately from Hillman or Eaton.
Print Settings
Printed with PETG at 0.15mm
PLA will likely work too but be more likely to crack
Printed face up with supports Everywhere
Snug style
0.2 Top Contact Z Distance
Increase if the supports are too difficult to remove.
3 Top Interface Layers
Installation
Shut off power AT THE BREAKER and use a non-contact voltage tester to confirm the power is not flowing in or around the switches/outlets you are working on.
Remove the screws holding the old wallplate to the wall
Pull off the old wallplate. It may stick to the paint if it's been there a while, so a gentle pry may be necessary
Install the new bracket using either the original screws or a new set of screws. DO NOT over-tighten. The screws will probably not go in as tightly, since it will warp more than traditional Polycarbonate plates.
Turn the breaker back on.