1984-1989 Porsche 911 vent connector clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement vent connector clip on p/n 911.572.041.00 and 911.572.041.01. Printed in TPU.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 28
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
The little clip that holds the vent vanes and allows you to move them broke after ~40 years. Unfortunately, this plastic clip is not sold and one would need to buy an entire new vent assembly.
Luckily we still had the remains of the original (see picture), so I was able to take some measurements and replicate the part. I printed it in TPU both for heat resistance, and because this clip is the only way that the vent vanes hold in place. There is no other source of friction for the vanes in the assembly, so I would not recommend using PETG or ABS.
Installation can be done completely from the front with a set of tweezers or small needle nose pliers. However, pulling the vent does make it a little easier.