Apprentice Cowl S 2 Mini 1.2M
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I found one at Thingiverse but the dimensions seemed to be a bit off so I reworked it.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 89
- Wydruki
- 0
- Wyświetlenia
- 456
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Reworked one I found elsewhere because the measurements were not to my liking.
I didn't compensate for the down thrust on the motor but other than that it fits like a glove while still using the spinner. The original didn't either. ( did this for a buddy in need of the cowl )
Printed nose up with generic PLA.
0% infill
Top Layers = 4 ( you could probably get away with 2 or 3 )
I actually stopped the print when it got to the shaft cut out area.
Bottom Layers =0
I used a brim to ensure it sticks to the bed.