Gridfinity 1×2 Bin — Magnet Holes + Finger Scoop | Baseplate Compatible (42 mm)

The single most useful print you'll make all year.

Gridfinity is the modular grid storage system that took over Printables — and for good reason. Print one baseplate, then fill it with bins sized exactly for your screws, SD cards, drill bits, batteries, LEGO, sewing notions, makeup, or office clutter. Everything has a place and nothing slides around.

This is a 1×2 bin (6U / 42 mm tall) built to the real Gridfinity dimensions so it drops straight into any standard 42 mm baseplate.

### Features

- 📐 True Gridfinity geometry — 42 mm pitch, accurate stepped base, seats perfectly in standard baseplates

- 🧲 8 magnet holes (Ø6.5 mm × 2.4 mm) — 4 per grid cell for Ø6 × 2 mm magnets, so bins stay put when you pull a drawer

- 👍 Front finger scoop — sweep small parts out easily, no fingernail fishing

- 🪣 Deep usable cavity — 6U height holds a lot per footprint

- 🖨 Prints flat & support-free — bottom on the plate, done

### Perfect for

Screws & fasteners · electronics & resistors · SD/microSD cards · drill & driver bits · craft & sewing supplies · makeup & jewelry · desk drawers · toolbox inserts

### Need a different size?

Drop a comment — easy to remix into 1×1, 2×2, taller/shorter, divided, or label-tab versions. Tell me what you'd store and I'll add it to the set.

---

## PRINT SETTINGS

- Material: PLA or PETG (PETG if it'll see oils/solvents in a workshop)

- Layer height: 0.20 mm

- Walls / perimeters: 3

- Infill: 10–15 % (gyroid or grid)

- **Supports:** None

- Orientation: As exported — open top up, feet on the plate

- Magnets (optional): Ø6 × 2 mm neodymium, press-fit or a dab of CA glue

- Print time: ~1–1.5 h · ~25 g

Tip: No baseplate yet? The bin still works great as a standalone drawer divider. Pair it with any Gridfinity baseplate on Printables to unlock the magnetic snap-in grid.