Anker Zolo Qi2 Charger Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A wall mount for the Anker Zolo Qi2 charger.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 104
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial
I designed this phone mount so I can charge my phone over night and use its Always-On display as a bedside clock.
It fits the Anker Zolo Qi2 charging pad: https://amzn.eu/d/05fnNduC
The phone can be mounted in landscape or, in case it is a device smaller than a Pixel 10, it might fit in portrait mode as well.
As you might have noticed, the print features a two tone look. It is not strictly required for the phone to charge. I just ran out of black PLA and switched to red along the way xD. Looks quite nice, as I think.
I printed it in black AmazonBasics PLA and switched to Panchroma Wine Red PLA half way through the print.
Recommended Print Settings:
Material: Any (PLA, PETG, ABS, etc. should all work perfectly fine)
Orientation: Print face down
Layer Height: 0.15mm (others should work fine either)
Infill: 15% (Gyroid)
I added a modifier cube in the slicer to increase the infill (100%) around the screw hole
Bottom layer is set to concentric
Supports: Yes, on the build plate only (to support the bridge with the screw hole)
Printed on a Prusa Mini+