Bicycle chainring guard 48t, 5-hole, M2 screw
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Prevents your clothing from getting caught between the chain and the sprocket.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 30
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Share Alike
This design uses 5 M2 x 12 mm screws.
The pilot holes are 2.1 x 13.5 mm and not threaded.
It's advised tapping the holes with the screws before installing on the chainring.
Be careful though and hold the tabs tight when doing so because the tabs might crack (mine did on 2 of them but it is still usable).
Make sure it fits your bike before printing.
Printed in PETG, 0.2 mm layer height.
IMPORTANT: Increase the tab's wall loops to 5.
- In the slicer, I added a 190 x 190 mm cylinder modifier in the center to increase the tab's wall loops. This is to help decrease the chances of the screw threads splitting the part.
Haven't test ridden it out yet. Will update later.
Update: werks :)