TopPeak Ratchet Rocket Organizer with Magnetic Bit Holders
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnetic organizer for the TopPeak Ratchet Rocket bit set. Holds all bits and the ratchet with strong magnets.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 91
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Complete magnetic organizer for the TopPeak Ratchet Rocket set. This design holds:
All bits from the ratchet set
The ratchet itself
Extension bar
Valve adapter
Required magnets: 12× 3×2 mm magnets (for bit holders and extension) + 1× 6×3 mm magnet (for ratchet)
Print orientation: Bits hole-side down for optimal results. Zero support needed in bit cavities — support blockers are placed exactly where the bits are to prevent this.
Important: Supports ARE required for the extension bar and valve adapter receiving areas. Ensure support blockers do not interfere with these zones. Pay attention to magnet polarity when installing, especially for the ratchet-holding magnet.
Magnet installation: The ratchet magnet is a print-in-place magnet — add a pause before the magnet hole gets covered. The other magnets are to be glued into place afterwards.
Perfect for makers who want a compact, functional storage solution for their TopPeak toolkit! This is my first project published, so I welcome your feedback and constructive criticism.