Desiccant dehydrator mod for Sovol SH02
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A dehydrator mod to turn your filament dryer into a desiccant/food dehydrator
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 17
- Wydruki
- 1
- Wyświetlenia
- 173
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This insert is what I came up with when I didn't want to buy a food dehydrator and looked at my Sovol SH02 filament dryer. This converts the SH02 into a desiccant/food dehydrator.
Instructions:
Print 1 base plate and 4 pegs for each upper plate. The pegs are a tight press fit on one side and a friction fit on the other.
Print Settings:
Material: Make sure the SH02 doesn't melt it. It can reach 70°C, normal PLA will turn soft
Layer height: 0.2mm
No raft
No supports
Infill: 5 - 15%
Remix Info:
The peg interface on the plates is 30mm x 5mm x 3mm with fully rounded corners.
The loose side of the pegs is offset by 0.1mm to each side and 0.2mm to the top