1 / 6
MiniMed 780G Protective TPU Case — FreeCare DIA (v1 Beta) — zdjęcie 1
1 / 6

MiniMed 780G Protective TPU Case — FreeCare DIA (v1 Beta)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Flexible TPU protective case for the Medtronic MiniMed 780G insulin pump.

Ocena
0 / 5
Polubienia
1
Pobrania
18
Wydruki
0
Wyświetlenia
85
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Medical Tools
Licencja
Creative Commons — Attribution — Noncommercial

Features
- Full wrap — covers back, sides, top and bottom
- Large front window — full access to the screen and the navigation buttons
- Rear keyhole slot — works with the original slide-on belt clip
- Top opening (Ø24 mm) — clears the reservoir / tubing connector
- Triangular shock-absorbing studs — on the sides, bottom and all corners (crush zone)
- Internal corner air-gaps — hollow crush zones behind the corners for impact absorption
-  Engraved inner label


#Material & print

- TPU 95A (e.g. Elegoo TPU 95A) — flexible
- Print back (closed side) down, front window up
- Manual / painted supports required on the front-window frame** — the frame above the screen overhangs the cavity and will sag in TPU without support. Paint supports only there (build-plate-only supports won't reach it). Easy to peel off TPU afterwards.
- See Recommended print settings below

#Important — please read (disclaimer)
- **Not affiliated with, endorsed by, or sponsored by Medtronic.** "MiniMed" and "780G" are trademarks of Medtronic plc, used **only to indicate compatibility**.
- This is a **hobbyist 3D-printed accessory, NOT a medical device** and not an official Medtronic product.
- **Use at your own risk.** Before relying on it, make sure the case does **not** block any button, the screen, the reservoir, the tubing/connector, ports, or the pump's **alarms / vibration**. You must still be able to fully operate the pump and clearly hear/feel all alerts. Remove it if it interferes in any way.
- Provided **"as is", without any warranty**.

#This is a v1 Beta
Fit is based on careful measurements but not mass-tested.
**Feedback on fit is very welcome** — comment with your results so I can refine it.


Credits
Designed by pepOo · parametric model in OpenSCAD.

 Material - TPU 95A (flexible)
 Nozzle temp - 225–230 °C (first layer +5)
 Bed temp - 45 °C
 Layer height - 0.20 mm (first layer 0.24)
 Walls / perimeters - 3
 Top / bottom layers - 4 / 4 
 Infill - 15 %, gyroid

Tagi