MiniMed 780G Protective TPU Case — FreeCare DIA (v1 Beta)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Flexible TPU protective case for the Medtronic MiniMed 780G insulin pump.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 19
- Makes
- 0
- Views
- 89
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Medical Tools
- License
- Creative Commons — Attribution — Noncommercial
Features
- Full wrap — covers back, sides, top and bottom
- Large front window — full access to the screen and the navigation buttons
- Rear keyhole slot — works with the original slide-on belt clip
- Top opening (Ø24 mm) — clears the reservoir / tubing connector
- Triangular shock-absorbing studs — on the sides, bottom and all corners (crush zone)
- Internal corner air-gaps — hollow crush zones behind the corners for impact absorption
- Engraved inner label
#Material & print
- TPU 95A (e.g. Elegoo TPU 95A) — flexible
- Print back (closed side) down, front window up
- Manual / painted supports required on the front-window frame** — the frame above the screen overhangs the cavity and will sag in TPU without support. Paint supports only there (build-plate-only supports won't reach it). Easy to peel off TPU afterwards.
- See Recommended print settings below
#Important — please read (disclaimer)
- **Not affiliated with, endorsed by, or sponsored by Medtronic.** "MiniMed" and "780G" are trademarks of Medtronic plc, used **only to indicate compatibility**.
- This is a **hobbyist 3D-printed accessory, NOT a medical device** and not an official Medtronic product.
- **Use at your own risk.** Before relying on it, make sure the case does **not** block any button, the screen, the reservoir, the tubing/connector, ports, or the pump's **alarms / vibration**. You must still be able to fully operate the pump and clearly hear/feel all alerts. Remove it if it interferes in any way.
- Provided **"as is", without any warranty**.
#This is a v1 Beta
Fit is based on careful measurements but not mass-tested.
**Feedback on fit is very welcome** — comment with your results so I can refine it.
Credits
Designed by pepOo · parametric model in OpenSCAD.
Material - TPU 95A (flexible)
Nozzle temp - 225–230 °C (first layer +5)
Bed temp - 45 °C
Layer height - 0.20 mm (first layer 0.24)
Walls / perimeters - 3
Top / bottom layers - 4 / 4
Infill - 15 %, gyroid